download
AUDIO CABLE CONNECTION 1. See Figure 3. Obtain the larger clip (4) and the coiled headset audio cable (2) from the kit. Install the 3.5 mm stereo jack end of the cable into the clip. 2. Connect the 3.5 mm stereo jack from the headset audio cable to the audio output socket on the Road Tech riser radio, satellite radio or other audio device. Position the clip in the area indicated in Figure 1, and rotate as needed to allow easy insertion and removal of the cable jack and audio output socket. 2 1 is04347 1. For FLHT models 2. For FXD, FXST, FLST, FLHR and FLTR models Figure 1. Clip Location NOTE Ambient temperature should be at least 60 °F (16 °C) for proper adhesion of the clip to the mounting surface. 3. Clean the clip mounting area with a mixture of 50 to 70% isopropyl alcohol and 30 to 50% distilled water. Allow to dry thoroughly. 4. Peel the liner from the adhesive backing of the clip. Carefully position the clip to the mounting surface, and press firmly into place. Hold the clip in position with steady pressure for 30 seconds. Be sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a) •Be sure audio connection harness or headset audio cable do not pinch, bind or interfere when handlebars are turned fully to left or right fork stops. 5. See Figure 3. Use the small clip (5) from the kit to retain any excess headset cable to the side of the console. Attach per Step 4. NOTES Allow AT LEAST 24 hours after applying the clip before exposing the area to vigorous washing, strong water spray or extreme weather. -J04930 1 of 2 PERATION 1. Plug in the coiled audio cable at the headset and audio source. 2. See Figure 2. Put the headset on as shown, with the headband across the back of the head, above the neck. Put the helmet on, and fasten securely
